Halfpipes done right

Halfpipe find the right fit for their preferences, it may be difficult, so the best thing is to make oneself. In this case you can be sure that all their needs will be satisfied and not afraid of something that is not perfect.

Although you can build one, to consider your friends in question not only make things easier, but even fun. Especially after it has done and all that and we know possonouso che is something we all built together for fun and adventure.

Do not worry, this project will not be as difficult as you might think at first. Just make a plan and stick TTO and at no time to be installed and ready for use.

The materials you need to do Halfpipe are easily obtainable, 8 sheets of plywood (3 / 4 "), stock (2 x 4), a 10" PVC pipe, some nails, screws and ½ laminate. To put all this together, you need a hammer, a fishing line, a tape measure, some paper and pencil, and a saw. Select a drill bit is also necessary.

The first thing you have to do is find a place. This determines how large the Halfpipe will be. Then put the design of the system, which consists of two parts proportions. Get the 2 x 4 stock and make a tense 4 "wide and 8" long. The surface must have two sections (4 x 8) and the plansupport around 7 and 7 / 8 "spaced from each other.

Next place the parentheses (horizontal and vertical) on the side. It should be about 3 "3 high, with three pieces. Use the fishing line to fashion a curve with a radius of about 5'7 ½". This should serve as the bowl Halfpipe.

Use the radio to make a side prepared, noting areas of support. Subscribe to the vertical sides using cruz States. They should be about7 and a half inches. Do not forget to double their point of beams of plywood so that it does not break when their application.

The plywood will serve as a terrace; connection with the screws. To create the platform and ramp, just double the floor of plywood. To make the route easier to use, a good place above the surface of the plywood.

The last cosad be based on the Halfpipe is the crushing of railwaysand (a platform and join the terrace). To mitigate the damage to these areas, get the 10 "PVC pipe. Use the screws to attach the plywood.

There will be times when we need to dismantle the Halfpipe. E 'for this reason it is necessary to use screws nails, and that will make it easier to pull it all together and apart. In addition to the mat with any Halfpipeterreni uncultivated to be protected from heavy rain will be needed.

NaturallyYou should regularly monitor the Halfpipe and replace parts that were widely used and indoss.